Polar RS400 User Manual download pdf (Page 38)

Polar OwnOptimizer

General

Successful training requires temporary overloading: longer exercise duration, higher intensity, or higher

total volume. In order to avoid severe overtraining, overloading must always be followed by an adequate

recovery period. With an inadequate recovery period, you may experience a decrease in performance as a

result of high training volumes, instead of improvement. Polar OwnOptimizer is an easy and reliable way to

determine whether your training program is optimally developing your performance. Polar OwnOptimizer is

developed for use by healthy adults.

Polar OwnOptimizer is a modification of a traditional orthostatic overtraining test. It is a perfect tool,

embedded in the running computer, for everyone training regularly, at least three times a week, for fitness

improvement or to reach competitive targets. This feature is based on heart rate and heart rate variability

measurements taken during an orthostatic test (standing up from relaxed resting). OwnOptimizer helps you

to optimize your training load during a training program so that you experience an increase in performance

and do not undertrain or overtrain in the long run. Polar OwnOptimizer is based on regular long-term

measurements of five heart rate parameters. Two of these five values are calculated at rest, one while

standing up, and two while standing. Each time you perform the test, the wrist unit saves the heart rate

values and compares them to the previous values registered.

Before the Test

Baseline Tests

When you use OwnOptimizer for the first time, six baseline tests should be conducted over a period of two

weeks to determine your personal baseline value. These baseline measurements should be taken during

two typical basic training weeks, not during heavy training weeks. The baseline measurements should

include tests taken after a training day and after recovery days.

Monitoring OwnOptimizer Values

After the baseline recordings, you should continue to perform the test 2-3 times a week. Test yourself

weekly in the morning following both a recovery day and a heavy training day (or a series of heavy training

days). An optional third test can be performed after a normal training day. OwnOptimizer may not provide

reliable information during detraining or in a very irregular training period. If you take a break from

exercise for 14 days or longer, the baseline tests should be performed again.

Performing the Test

The test should always be taken in standardized/similar conditions in order to get the most reliable results.

It is recommended that you take the test in the morning before breakfast. The following basic

requirements apply:

• Wear the transmitter. For further information, see Start Training (page 14).

• You should be relaxed and calm.

• You can be seated in a relaxed position or lying in bed. The position should always be the same when you

do the test.

• The test can take place anywhere – at home, in the office, at a health club – as long as the test

environment is peaceful. There should be no disturbing noises (for example, television, radio or telephone)

or other people talking to you.

• Avoid eating, drinking and smoking 2-3 hours prior to the test.

Performing the Test

Select Test > Optimizer > Start > Optimizer Lie Down

Arrows indicate the test is ongoing. Do not move during this first part of the test, which lasts 3 minutes.

ENGLISH

38 Tests

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Comments to this Manuals

No comments

Polar RS400 User Manual Page 38

Comments to this Manuals

Related products and manuals for Heart rate monitors Polar RS400